Garden tool pruning, tree cutting operation method

Although the landscaping environment is everyone's responsibility, but also the help of our good helpers, the following Zhejiang Wugu Paoshin Industries Co., Ltd for everyone to share gardening tools pruning, tree cutting tips!
Garden tools For long-fiber cork, the cut sapwood cut prevents it from breaking when it falls. Cut the sides of the trunk at the same height as the bottom of the groove, about 1/10 the diameter of the trunk. If the trunk is thick, the sawing depth must not be wider than the guide. If the wood is spoiled, do not cut the sapwood cut. The sawing kerf is sawed slightly above the bottom of the inverted tree groove and is horizontally sawed. A non-sawing area of ​​approximately 1/10 the diameter of the trunk is left between the felling cut and the inverted tree groove to act as a ridge. In time, wedge the wedge into the felling cut. Use only wooden, aluminum or plastic wedges. Never use steel wedges as this may damage the chain saw chain and cause a rebound. Broken ridges help to control the tree's backwards. Never cut through the ridges, otherwise you will not be able to control the backwards, which may lead to accidents.
If the diameter of the trunk is greater than twice the length of the guide, or the diameter of the trunk is particularly large, most of the tree core is not sawn. In order to prevent the tree from breaking and want to accurately control the backward direction of the tree, it is necessary to saw the tree heart. Use a chain saw to puncture the center of the inverted tree groove, and then swing the guide from top to bottom.
Garden tools can be cut into simple fan-shaped kerfs for thinner trunks. The inserted wood tooth is stuck behind the broken ridge, so that the chain saw swings as the axis. It is necessary to pay attention to only swing to the broken ridge, so that the inserted wooden teeth can be rotated around the trunk.
When the garden tool cuts a thick trunk, the trunk diameter is larger than the length of the chain saw guide, and the partition block cutting method is suitable. When cutting the first incision, the end of the guide plate should just reach the broken ridge of the trunk, so that the chain saw can be horizontally and swinged as much as possible, with the wooden teeth as the fulcrum, and the increased kerf should be as small as possible. When repositioning the saw chain to the next kerf, the entire guide should be embedded in the kerf to prevent uneven grooving, and the operation of clamping the wood teeth, and then insert a wedge into the slit. The last time you saw the saw, you only need to saw a simple fan-shaped cut, but you can't cut the broken ridge.

gardening tools